The front of the grip should be on the side of the clip of the cap :ħ- Attach each cap on each edge of the Ivan mod base =) use tape is needed.ġ4- Adjust the center of gravity with tape. Keep 9 stripes from the frontĤ- Use your plier to stretch the sailor grip (it’s better to use a sub, the one that feels more plastic than silicon, because it is slightly heavier) and add it above CT caps :ĥ- Optional : Add the metal ring as shownĦ- Add the anyball grip above sailor gel grip sub. Keep 19mm of the thinner part :ģ- With a circular file, sand inside of the CT cap so the tip can fit inside :ģ- Cut your anyball grip as shown. – 2 metal rings (0.8gr each, ID6mm and OD11mm) Can be change by Penzgar ringsġ- Prepare your Ivan mod base for 17cm longĢ- Cut CT cap at the red line. – 1 Ivan mod base (That’s to say, 1 whole ST with 1 half on each side) – Name : Ivan-Menowa* Hybrid (IM* Hybrid) Featured picture : credit goes to Vôre-Tèx
